Pool Choice Stabilizer & Conditioner

• Contains Cyanuric Acid

• Reduces chlorine loss

• Improves chlorine effectiveness

• Effective and easy to use

Use a reliable test kit to determine the stabilizer concentration in the pool water. Follow the chart below to bring the pool water to the desired range of 40-100 ppm. If the pool is new, just refilled, or has no stabilizer; add 4 oz. of this product per 1,000 gallons to give the desired 40-100 ppm.

Add this product slowly into the skimmer, or if desired, premix in a pail of warm water and then add directly to the skimmer. Be sure the filter is clean. Recirculate the water continuously for 24 hours to dissolve completely. Always maintain the chlorine residual in your pool at 2.0-4.0 ppm and pH at 7.4-7.6.

CAUTION. Contains Cyanuric Acid. May cause eye irritation. Avoid contact with eyes, skin, and clothing. Avoid breathing dust and use adequate ventilation. Wear goggles and use rubber gloves when handling. Wash thoroughly after handling. If product gets on clothing, remove and wash before

reuse. Do not mix with other products.

IF IN EYES: Immediately flush eyes for 15 minutes with plenty of water, while holdingeyelids apart. Call a physician.

IF ON SKIN OR CLOTHING: Brush off excess chemical and wash skin with soap and water for 15 minutes. Remove contaminated clothing and wash before reuse. Call physician if irritation persists.

IF SWALLOWED: Give victim several glasses of water. Do not induce vomiting. Never give anything by mouth to an unconscious person. Call a physician.

IF INHALED: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Seek medical attention.

Store closed container in a cool, dry, well-ventilated place. When container is empty, rinse thoroughly with water, wrap securely in newspaper and place in trash collection.